| 1. |
- Wang, Fang, et al.
(author)
-
Emerging contaminants: A One Health perspective
- 2024
-
In: Innovation. - 2666-6758. ; 5
-
Research review (peer-reviewed)abstract
- Environmental pollution is escalating due to rapid global development that often prioritizes human needs over planetary health. Despite global efforts to mitigate legacy pollutants, the continuous introduction of new substances remains a major threat to both people and the planet. In response, global initiatives are focusing on risk assessment and regulation of emerging contaminants, as demonstrated by the ongoing efforts to establish the UN's Intergovernmental Science-Policy Panel on Chemicals, Waste, and Pollution Prevention. This review identifies the sources and impacts of emerging contaminants on planetary health, emphasizing the importance of adopting a One Health approach. Strategies for monitoring and addressing these pollutants are discussed, underscoring the need for robust and socially equitable environmental policies at both regional and international levels. Urgent actions are needed to transition toward sustainable pollution management practices to safeguard our planet for future generations.
|
|
| 2. |
- Gulshan, Samina, et al.
(author)
-
Kinetic investigation on the catalytic pyrolysis of plastic fractions of waste electrical and electronic equipment (WEEE) : A mathematical deconvolution approach
- 2024
-
In: Waste Management. - : Elsevier Ltd. - 0956-053X .- 1879-2456. ; 187, s. 156-166
-
Journal article (peer-reviewed)abstract
- Waste electrical and electronic equipment (WEEE) has become a critical environmental problem. Catalytic pyrolysis is an ideal technique to treat and convert the plastic fraction of WEEE into chemicals and fuels. Unfortunately, research using real WEEE remains relatively limited. Furthermore, the complexity of WEEE complicates the analysis of its pyrolytic kinetics. This study applied the Fraser-Suzuki mathematical deconvolution method to obtain the pseudo reactions of the thermal degradation of two types of WEEE, using four different catalysts (Al2O3, HBeta, HZSM-5, and TiO2) or without a catalyst. The main contributor(s) to each pseudo reaction were identified by comparing them with the pyrolysis results of the pure plastics in WEEE. The nth order model was then applied to estimate the kinetic parameters of the obtained pseudo reactions. In the low-grade electronics pyrolysis, the pseudo-1 reaction using TiO2 as a catalyst achieved the lowest activation energy of 92.10 kJ/mol, while the pseudo-2 reaction using HZSM-5 resulted in the lowest activation energy of 101.35 kJ/mol among the four catalytic cases. For medium-grade electronics, pseudo-3 and pseudo-4 were the main reactions for thermal degradation, with HZSM-5 and TiO2 yielding the lowest pyrolytic activation energies of 75.24 and 226.39 kJ/mol, respectively. This effort will play a crucial role in comprehending the pyrolysis kinetic mechanism of WEEE and propelling this technology toward a brighter future.
|
|
| 3. |
- Gulshan, Samina, et al.
(author)
-
Kinetic investigation on the catalytic pyrolysis of plastic fractions of waste electrical and electronic equipment (WEEE): A mathematical deconvolution approach
- 2024
-
In: Waste Management. - : Elsevier BV. - 0956-053X .- 1879-2456. ; 187, s. 156-166
-
Journal article (peer-reviewed)abstract
- Waste electrical and electronic equipment (WEEE) has become a critical environmental problem. Catalytic pyrolysis is an ideal technique to treat and convert the plastic fraction of WEEE into chemicals and fuels. Unfortunately, research using real WEEE remains relatively limited. Furthermore, the complexity of WEEE complicates the analysis of its pyrolytic kinetics. This study applied the Fraser-Suzuki mathematical deconvolution method to obtain the pseudo reactions of the thermal degradation of two types of WEEE, using four different catalysts (Al2O3, HBeta, HZSM-5, and TiO2) or without a catalyst. The main contributor(s) to each pseudo reaction were identified by comparing them with the pyrolysis results of the pure plastics in WEEE. The nth order model was then applied to estimate the kinetic parameters of the obtained pseudo reactions. In the low-grade electronics pyrolysis, the pseudo-1 reaction using TiO2 as a catalyst achieved the lowest activation energy of 92.10 kJ/mol, while the pseudo-2 reaction using HZSM-5 resulted in the lowest activation energy of 101.35 kJ/mol among the four catalytic cases. For medium-grade electronics, pseudo-3 and pseudo-4 were the main reactions for thermal degradation, with HZSM-5 and TiO2 yielding the lowest pyrolytic activation energies of 75.24 and 226.39 kJ/mol, respectively. This effort will play a crucial role in comprehending the pyrolysis kinetic mechanism of WEEE and propelling this technology toward a brighter future.
|
|
| 4. |
- Jin, Yanghao, et al.
(author)
-
A novel three-stage ex-situ catalytic pyrolysis process for improved bio-oil yield and quality from lignocellulosic biomass
- 2024
-
In: Energy. - : Elsevier Ltd. - 0360-5442 .- 1873-6785. ; 295
-
Journal article (peer-reviewed)abstract
- This study aims to improve the quality and yield of bio-oil produced from ex-situ catalytic pyrolysis of lignocellulosic biomass (sawdust) using a combination of stage catalysts with Al-MCM-41, HZSM-5, and ZrO2. The research employed various methods, including thermogravimetric analysis (TGA), differential scanning calorimetry, bench-scale experiments, and process simulations to analyze the kinetics, thermodynamics, products, and energy flows of the catalytic upgrading process. The introduction of ZrO2 enhances the yield of monoaromatic hydrocarbons (MAHs) in heavy organics. Compared with the dual-catalyst case, the MAHs yield escalates by approximately 344% at a catalyst ratio of 1:3:0.25. Additionally, GC-MS data indicate that the incorporation of ZrO2 promotes the deoxygenation reaction of the guaiacol compound and the oligomerization reactions of PAHs. The integration of ZrO2 as the third catalyst enhances the yield of heavy organics significantly, achieving 16.85% at a catalyst ratio of 1:3:1, which increases by nearly 35.6% compared to the dual-catalyst case. Also, the addition of ZrO2 as the third catalyst enhanced the energy distribution in heavy organics. These findings suggest that the combination of these catalysts improves the fuel properties and yields of the bio-oil.
|
|
