1. |
- Parreiras, Lucas S., et al.
(författare)
-
Engineering and two-stage evolution of a lignocellulosic hydrolysate-tolerant Saccharomyces cerevisiae strain for anaerobic fermentation of xylose from AFEX pretreated corn stover
- 2014
-
Ingår i: PLOS ONE. - : Public Library of Science (PLoS). - 1932-6203. ; 9:9
-
Tidskriftsartikel (refereegranskat)abstract
- The inability of the yeast Saccharomyces cerevisiae to ferment xylose effectively under anaerobic conditions is a major barrier to economical production of lignocellulosic biofuels. Although genetic approaches have enabled engineering of S. cerevisiae to convert xylose efficiently into ethanol in defined lab medium, few strains are able to ferment xylose from lignocellulosic hydrolysates in the absence of oxygen. This limited xylose conversion is believed to result from small molecules generated during biomass pretreatment and hydrolysis, which induce cellular stress and impair metabolism. Here, we describe the development of a xylose-fermenting S. cerevisiae strain with tolerance to a range of pretreated and hydrolyzed lignocellulose, including Ammonia Fiber Expansion (AFEX)-pretreated corn stover hydrolysate (ACSH). We genetically engineered a hydrolysate-resistant yeast strain with bacterial xylose isomerase and then applied two separate stages of aerobic and anaerobic directed evolution. The emergent S. cerevisiae strain rapidly converted xylose from lab medium and ACSH to ethanol under strict anaerobic conditions. Metabolomic, genetic and biochemical analyses suggested that a missense mutation in GRE3, which was acquired during the anaerobic evolution, contributed toward improved xylose conversion by reducing intracellular production of xylitol, an inhibitor of xylose isomerase. These results validate our combinatorial approach, which utilized phenotypic strain selection, rational engineering and directed evolution for the generation of a robust S. cerevisiae strain with the ability to ferment xylose anaerobically from ACSH.
|
|
2. |
- Steuwer, Axel, et al.
(författare)
-
A combined approach to microstructure mapping of an Al-Li AA2199 friction stir weld
- 2011
-
Ingår i: Acta Materialia. - : Elsevier BV. - 1873-2453 .- 1359-6454. ; 59:8, s. 3002-3011
-
Tidskriftsartikel (refereegranskat)abstract
- A wide range of complementary techniques are used to build up a detailed picture of the microstructural zones found in friction stir welds (FSW) in an advanced AA2199 Al-Li alloy. Neutron and synchrotron X-ray diffraction, transmission electron microscopy, differential scanning calorimetry, small angle X-ray scattering, scanning electron microscopy, electron backscatter diffraction (EBSD) and hardness mapping are brought together to build up a detailed two-dimensional picture of the grain morphology, precipitate type, size, volume fraction and matrix solute content across the weld cross section and to explain the general lack of a W-shaped hardness profile across FSW in third-generation Al-Li-Cu Mg alloys. Dissolution of the age-hardening phases occurred in different regions of the weld, depending on their respective solvus temperatures, with 5' dissolving within the heat-affected zone and T-1 coarsening in the thermo-mechanically affected zone before going into solution in the weld nugget. Changes to the precipitate distribution, and especially to the T1 phase, are linked to a significant reduction in hardness (strength) and unstrained lattice parameter across the weld zone. It was also possible to show that the low recovery of nugget zone hardness is primarily due to its poor natural ageing response. (C) 2011 Acta Materialia Inc. Published by Elsevier Ltd. All rights reserved.
|
|