| 1. |
- Ericsson, A., et al.
(författare)
-
Crystallization of a Zr-based metallic glass produced by laser powder bed fusion and suction casting
- 2021
-
Ingår i: Journal of Non-Crystalline Solids. - : Elsevier. - 0022-3093 .- 1873-4812. ; 571
-
Tidskriftsartikel (refereegranskat)abstract
- The crystallization behaviour during low temperature annealing of samples of the Zr59.3Cu28.8Al10.4Nb1.5 (at%) bulk metallic glass produced by suction casting and the laser powder bed fusion (LPBF) process were studied with small angle neutron scattering (SANS), X-ray diffraction and scanning electron microscopy. The in-situ SANS measurements during isothermal annealing reveals that the phase separation in the LPBF processed material proceeds at a smaller characteristic length-scale than the cast material. Quantitative analysis of the SANS data shows that, while the crystallization process in both materials proceed through rapid nucleation followed by diffusion limited growth, the LPBF processed material crystallizes with a smaller cluster size and at a higher rate. The smaller cluster size is attributed to the elevated oxygen content in the LPBF processed material which reduces the nucleation barrier and thus the thermal stability.
|
|
| 2. |
- Chien, Yu-Chuan, 1990-, et al.
(författare)
-
Correlations between precipitation reactions and electrochemical performance of lithium-sulfur batteries probed by operando scattering techniques
- 2022
-
Ingår i: Chem. - : Elsevier. - 2451-9294. ; 8:5
-
Tidskriftsartikel (refereegranskat)abstract
- A comprehensive description of electrochemical processes in the positive electrode of lithium-sulfur batteries is crucial for the utilization of active material. However, the discharge mechanisms are complicated due to various reactions in multiple phases and the tortuosity of the highly porous carbon matrix. In this work, simultaneous measurements of small-angle and wide-angle scattering and cell resistance are performed on operating lithium-sulfur cells. Results indicate that precipitates grow mostly in number, not in size, and that the structure of the carbon matrix is not affected. The comparison of the small-angle and wide-angle scattering reveals the amorphous discharge products found at a low discharge rate. Further analysis demonstrates the correlation between the diffusion resistance and the compositional change of electrolyte in the mesopores at the end of discharge, which suggests that Li-ion deficiency is the limiting factor for sulfur utilization at a medium discharge rate.
|
|
| 3. |
- Dicko, Cedric, et al.
(författare)
-
NUrF-Optimization of in situ UV-vis and fluorescence and autonomous characterization techniques with small-angle neutron scattering instrumentation
- 2020
-
Ingår i: Review of Scientific Instruments. - : AMER INST PHYSICS. - 0034-6748 .- 1089-7623. ; 91:7
-
Tidskriftsartikel (refereegranskat)abstract
- We have designed, built, and validated a (quasi)-simultaneous measurement platform called NUrF, which consists of neutron small-angle scattering, UV-visible, fluorescence, and densitometry techniques. In this contribution, we illustrate the concept and benefits of the NUrF setup combined with high-performance liquid chromatography pumps to automate the preparation and measurement of a mixture series of Brij35 nonionic surfactants with perfluorononanoic acid in the presence of a reporter fluorophore (pyrene).
|
|
| 4. |
- Gustafsson, Emil, et al.
(författare)
-
Understanding interactions of plasticisers with a phospholipid monolayer
- 2024
-
Ingår i: Soft Matter. - : Royal Society of Chemistry. - 1744-683X .- 1744-6848. ; 20:13, s. 2892-2899
-
Tidskriftsartikel (refereegranskat)abstract
- The use of DEHP (diethylhexyl phthalate) is now banned for most applications in Europe; the exception is for blood bags, where its toxicity is overshadowed by its ability to extend the storage life of red blood cells. Another plasticiser, BTHC (butanoyl trihexyl citrate), is used in paediatric blood bags but does not stabilise blood cells as effectively. Interactions between plasticisers and lipids are investigated with a phospholipid, DMPC, to understand the increased stability of blood cells in the presence of DEHP as well as bioaccumulation and identify differences with BTHC. Mixed monolayers of DMPC and DEHP or BTHC were studied on Langmuir troughs where surface pressure/area isotherms can be measured. Neutron reflection measurements were made to determine the composition and structure of these mixed layers. A large amount of plasticiser can be incorporated into a DMPC monolayer but once an upper limit is reached, plasticiser is selectively removed from the interface at high surface pressures. The upper limit is found to occur between 40–60 mol% for DEHP and 20–40 mol% for BTHC. The areas per molecule are also different with DEHP being in the range of 50–100 Å2 and BTHC being 65–120 Å2. Results indicate that BTHC does not fit as well as DEHP in DMPC monolayers which could help explain the differences observed with regards to the stability of blood cells.
|
|
| 5. |
- Gustafsson, Emil, et al.
(författare)
-
Understanding interactions of plasticisers with a phospholipid monolayer
- 2024
-
Ingår i: Soft Matter. - : Royal Society of Chemistry. - 1744-683X .- 1744-6848. ; 20:13, s. 2892-2899
-
Tidskriftsartikel (refereegranskat)abstract
- The use of DEHP (diethylhexyl phthalate) is now banned for most applications in Europe; the exception is for blood bags, where its toxicity is overshadowed by its ability to extend the storage life of red blood cells. Another plasticiser, BTHC (butanoyl trihexyl citrate), is used in paediatric blood bags but does not stabilise blood cells as effectively. Interactions between plasticisers and lipids are investigated with a phospholipid, DMPC, to understand the increased stability of blood cells in the presence of DEHP as well as bioaccumulation and identify differences with BTHC. Mixed monolayers of DMPC and DEHP or BTHC were studied on Langmuir troughs where surface pressure/area isotherms can be measured. Neutron reflection measurements were made to determine the composition and structure of these mixed layers. A large amount of plasticiser can be incorporated into a DMPC monolayer but once an upper limit is reached, plasticiser is selectively removed from the interface at high surface pressures. The upper limit is found to occur between 40-60 mol% for DEHP and 20-40 mol% for BTHC. The areas per molecule are also different with DEHP being in the range of 50-100 Å2 and BTHC being 65-120 Å2. Results indicate that BTHC does not fit as well as DEHP in DMPC monolayers which could help explain the differences observed with regards to the stability of blood cells.
|
|
| 6. |
- Hemming, Joanna M., et al.
(författare)
-
Changes to lung surfactant monolayers upon exposure to gas phase ozone observed using X-ray and neutron reflectivity
- 2022
-
Ingår i: Environmental Science. - : Royal Society of Chemistry. - 2634-3606. ; 2:4, s. 753-760
-
Tidskriftsartikel (refereegranskat)abstract
- Exposure to the secondary pollutant ozone in ambient air is associated with adverse health effects when inhaled. In this work we use surface pressure measurements, combined with X-ray and neutron reflection, to observe changes in a layer of lung surfactant at the air water interface when exposed to gas phase ozone. The results demonstrate that the layer reacts with ozone changing its physical characteristics. A slight loss of material, a significant thinning of the layer and increased hydration of the surfactant material is observed. The results support the hypothesis that unsaturated lipids present in lung surfactant are still susceptible to rapid reaction with ozone and the reaction changes the properties of the interfacial layer.
|
|
| 7. |
- Jones, Stephanie H., et al.
(författare)
-
Aqueous Radical Initiated Oxidation of an Organic Monolayer at the Air-Water Interface as a Proxy for Thin Films on Atmospheric Aerosol Studied with Neutron Reflectometry
- 2023
-
Ingår i: Journal of Physical Chemistry A. - : American Chemical Society (ACS). - 1089-5639 .- 1520-5215. ; 127:42, s. 8922-8934
-
Tidskriftsartikel (refereegranskat)abstract
- Neutron reflectometry has been used to study the radical initiated oxidation of a monolayer of the lipid 1,2-distearoyl-sn-glycero-3-phosphocholine (DSPC) at the air–solution interface by aqueous-phase hydroxyl, sulfate, and nitrate radicals. The oxidation of organic films at the surface of atmospheric aqueous aerosols can influence the optical properties of the aerosol and consequently can impact Earth’s radiative balance and contribute to modern climate change. The amount of material at the air–solution interface was found to decrease on exposure to aqueous-phase radicals which was consistent with a multistep degradation mechanism, i.e., the products of reaction of the DSPC film with aqueous radicals were also surface active. The multistep degradation mechanism suggests that lipid molecules in the thin film degrade to form progressively shorter chain surface active products and several reactive steps are required to remove the film from the air–solution interface. Bimolecular rate constants for oxidation via the aqueous phase OH radical cluster around 1010 dm3 mol–1 s–1. Calculations to determine the film lifetime indicate that it will take ∼4–5 days for the film to degrade to 50% of its initial amount in the atmosphere, and therefore attack by aqueous radicals on organic films could be atmospherically important relative to typical atmospheric aerosol lifetimes.
|
|
| 8. |
- Olsmats, Eleonora, et al.
(författare)
-
Pea protein [Pisum sativum] as stabilizer for oil/water emulsions
- 2024
-
Ingår i: Advances in Colloid and Interface Science. - : Elsevier. - 0001-8686 .- 1873-3727. ; 326
-
Tidskriftsartikel (refereegranskat)abstract
- A map of stability for various water/oil/pea protein compositions has been plotted from the numerous reported results. Two clear regions of stability were identified. High internal oil phase emulsions with 70–80%, v/v oil content stabilized by total pea protein concentration <2.5%, w/v showed stability. Low oil content of 10–30%, v/v for a range of total pea protein concentrations >0.5%, w/v have also been identified as stable. Intermediate oil content and pea protein concentrations >4% w/v are unexplored regions and are likely to be areas of fruitful future research. The wide range of stability suggests that different stabilization mechanisms could be important for different compositions and careful consideration has to be taken to avoid oversimplification. Both stabilization with particles, i.e. Pickering emulsions, and protein unfolding have been suggested as mechanisms. The diverse way of describing stability makes it difficult to intercompare results in different studies. A summary of different oil types used have been presented and several properties such as dynamic viscosity, density, the dielectric constant and interfacial tension have been summarized for common vegetable oils. The type of vegetable oil and emulsion preparation techniques were seen to have rather little effect on emulsion stability. However, the different extraction methods and processing of the pea material had more effect, which could be attributed to changing composition of different proteins and to the states of aggregation and denaturing. Careful consideration has to be taken in the choice of extraction method and an increased understanding of what contributes to the stability is desirable for further progress in research and eventual product formulation.
|
|
| 9. |
- Shepherd, Rosalie H., et al.
(författare)
-
Measurement of gas-phase OH radical oxidation and film thickness of organic films at the air-water interface using material extracted from urban, remote and wood smoke aerosol
- 2022
-
Ingår i: Environmental Science. - : Royal Society of Chemistry (RSC). - 2634-3606. ; 2:4, s. 574-590
-
Tidskriftsartikel (refereegranskat)abstract
- The presence of an organic film on a cloud droplet or aqueous aerosol particle has the potential to alter the chemical, optical and physical properties of the droplet or particle. In the study presented, water insoluble organic materials extracted from urban, remote (Antarctica) and wood burning atmospheric aerosol were found to have stable, compressible, films at the air-water interface that were typically similar to 6-18 angstrom thick. These films are reactive towards gas-phase OH radicals and decay exponentially, with bimolecular rate constants for reaction with gas-phase OH radicals of typically 0.08-1.5 x 10(-10) cm(3) molecule(-1) s(-1). These bimolecular rate constants equate to initial OH radical uptake coefficients estimated to be similar to 0.6-1 except woodsmoke (similar to 0.05). The film thickness and the neutron scattering length density of the extracted atmosphere aerosol material (from urban, remote and wood burning) were measured by neutron reflection as they were exposed to OH radicals. For the first time neutron reflection has been demonstrated as an excellent technique for studying the thin films formed at air-water interfaces from materials extracted from atmospheric aerosol samples. Additionally, the kinetics of gas-phase OH radicals with a proxy compound, the lipid 1,2-distearoyl-sn-glycero-3-phosphocholine (DSPC) was studied displaying significantly different behaviour, thus demonstrating it is not a good proxy for atmospheric materials that may form films at the air-water interface. The atmospheric lifetimes, with respect to OH radical oxidation, of the insoluble organic materials extracted from atmospheric aerosol at the air-water interface were a few hours. Relative to a possible physical atmospheric lifetime of 4 days, the oxidation of these films is important and needs inclusion in atmospheric models. The optical properties of these films were previously reported [Shepherd et al., Atmos. Chem. Phys., 2018, 18, 5235-5252] and there is a significant change in top of the atmosphere albedo for these thin films on core-shell atmospheric aerosol using the film thickness data and confirmation of stable film formation at the air-water interface presented here.
|
|
