Sökning: onr:"swepub:oai:DiVA.org:liu-73808" >
Identification of S...
Identification of Subsurface Deformation in Machining of Inconel 718
-
- Zhou, Jinming (författare)
- Lund University,Lunds universitet,Industriell Produktion,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Production and Materials Engineering,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Bushlya, Volodymyr (författare)
- Lund University,Lunds universitet,Industriell Produktion,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Production and Materials Engineering,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Peng, Ru (författare)
- Linköpings universitet,Konstruktionsmaterial,Tekniska högskolan
-
visa fler...
-
- Ståhl, Jan-Eric (författare)
- Lund University,Lunds universitet,Industriell Produktion,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Production and Materials Engineering,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- Trans Tech Publications Inc. 2011
- 2011
- Engelska.
-
Ingår i: Applied Mechanics and Materials. - : Trans Tech Publications Inc.. - 1660-9336 .- 1662-7482. ; 117-119, s. 1681-1688
- Relaterad länk:
-
http://dx.doi.org/10...
-
visa fler...
-
https://urn.kb.se/re...
-
https://doi.org/10.4...
-
https://lup.lub.lu.s...
-
visa färre...
Abstract
Ämnesord
Stäng
- There is considerable industrial significance to understand the nature of subsurface deformation under the machined surface for correct prediction of surface properties in machined components based upon the machined conditions and material behaviors that give rise to them. In this study, high speed machining of Inconel 718 was carried with whisker reinforced ceramic cutting tool under different conditions of tool wear, coolant state and cutting parameters. The objective of the present investigation was to determine the effect of both cutting parameters and tool wear on the plastic deformation in the subsurface region of Inconel 718 after the finishing machining with above process conditions. The surface and subsurface region of machined specimens were examined using a high resolution scan electron microscope (HRSEM) and EBSD technique, microhardness measurements were also conducted on the test samples, accordingly plastic strain analysis were carried out.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
Nyckelord
- Ceramic
- Deformation
- Inconel 718
- Nickel Alloy
- Surface Integrity
- Inconel718
- Ceramics
- Nickel alloy
- Deformation
- Surface integrity
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas