Sökning: onr:"swepub:oai:research.chalmers.se:28368b5e-f622-47a5-87dc-4772e239311f" >
A TDD Distributed M...
A TDD Distributed MIMO Testbed Using a 1-bit Radio-Over-Fiber Fronthaul Architecture
-
- Aabel, Lise (författare)
- Telefonaktiebolaget L M Ericsson,Ericsson
-
- Jacobsson, Sven, 1990 (författare)
- Telefonaktiebolaget L M Ericsson,Ericsson
-
- Coldrey, Mikael, 1972 (författare)
- Telefonaktiebolaget L M Ericsson,Ericsson
-
visa fler...
-
- Olofsson, Frida, 1992 (författare)
- Chalmers tekniska högskola,Chalmers University of Technology
-
- Durisi, Giuseppe, 1977 (författare)
- Chalmers tekniska högskola,Chalmers University of Technology
-
- Fager, Christian, 1974 (författare)
- Chalmers tekniska högskola,Chalmers University of Technology
-
visa färre...
-
(creator_code:org_t)
- 2024
- 2024
- Engelska.
-
Ingår i: IEEE Transactions on Microwave Theory and Techniques. - 0018-9480 .- 1557-9670. ; In Press
- Relaterad länk:
-
https://research.cha...
-
visa fler...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- We present the uplink and downlink of a time-division duplex distributed multiple-input multiple-output (D-MIMO) testbed, based on a 1-bit radio-over-fiber architecture, which is low cost and scalable. The proposed architecture involves a central unit (CU) that is equipped with 1-bit digital-to-analog and analog-to-digital converters, operating at 10 GS/s. The CU is connected to multiple single-antenna remote radio heads (RRHs) via optical fibers, over which a binary radio frequency (RF) waveform is transmitted. In the uplink, a binary RF waveform is generated at the RRHs by a comparator, whose inputs are the received RF signal and a suitably designed dither signal. In the downlink, a binary RF waveform is generated at the CU via bandpass sigma-delta modulation. Our measurement results show that low error-vector magnitude (EVM) can be achieved in both the uplink and the downlink, despite 1-bit sampling at the CU. Specifically, for point-to-point over-cable transmission between a single user equipment (UE) and a CU equipped with a single RRH, we report, for a 10-MBd signal using single-carrier (SC) 16 quadratic-amplitude modulation (QAM) modulation, an EVM of 3.3% in the downlink, and of 4.5% in the uplink. We then consider a CU connected to three RRHs serving over the air two UEs, and show that, after over-the-air reciprocity calibration, a downlink zero-forcing precoder designed on the basis of uplink channel estimates at the CU achieves an EVM of 6.4% and 10.9% at UE 1 and UE 2, respectively. Finally, we investigate the ability of the proposed architecture to support orthogonal frequency-division multiplexing (OFDM) waveforms, and its robustness against both in-band and out-of-band interference.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Elektroteknik och elektronik -- Telekommunikation (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Electrical Engineering, Electronic Engineering, Information Engineering -- Telecommunications (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Elektroteknik och elektronik -- Kommunikationssystem (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Electrical Engineering, Electronic Engineering, Information Engineering -- Communication Systems (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Elektroteknik och elektronik -- Signalbehandling (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Electrical Engineering, Electronic Engineering, Information Engineering -- Signal Processing (hsv//eng)
Nyckelord
- Modulation
- Downlink
- Optical fibers
- 1-bit sampling
- radio-over-fiber
- Noise
- Quantization (signal)
- RF signals
- Uplink
- Distributed multiple-input multiple-output (D-MIMO)
Publikations- och innehållstyp
- art (ämneskategori)
- ref (ämneskategori)
Hitta via bibliotek
Till lärosätets databas