Sökning: id:"swepub:oai:DiVA.org:hv-13539" >
Process Parameter I...
-
Badgujar, Amol C.Centre for Solar Energy Materials, ARCI, Hyderabad, India
(författare)
Process Parameter Impact on Selective Laser Ablation of Bilayer Molybdenum Thin Films for CIGS Solar Cell Applications
- Artikel/kapitelEngelska2018
Förlag, utgivningsår, omfång ...
-
California, USA :American Scientific Publishers,2018
-
printrdacarrier
Nummerbeteckningar
-
LIBRIS-ID:oai:DiVA.org:hv-13539
-
https://urn.kb.se/resolve?urn=urn:nbn:se:hv:diva-13539URI
-
https://doi.org/10.1166/mat.2018.1540DOI
Kompletterande språkuppgifter
-
Språk:engelska
-
Sammanfattning på:engelska
Ingår i deldatabas
Klassifikation
-
Ämneskategori:ref swepub-contenttype
-
Ämneskategori:art swepub-publicationtype
Anmärkningar
-
Cu(In,Ga)Se2 or CIGS absorber layers are a promising candidate for thin film solar cells, with efficiency exceeding 22% having already been demonstrated at the cell level and their commercialization been ramped up. Scribing by selective ablation to achieve monolithic integration is an essential step in CIGS module making to divide a large area cell into a series of inter-connected smaller cells. P1 scribing or electrical isolation of back contact is an essential part of the monolithic integration. Laser-induced scribing of Molybdenum (Mo) back contact of a CIGS solar cell is highly sensitive to process parameters like laser power, pulse duration, and pulse repetition frequency. The above parameters control the scribe width, heat affected zone and process residue directly or indirectly, thereby affecting electrical isolation and module performance. Influence of laser process parameters on scribing of a bilayer Mo thin film back contact has been investigated and is being reported. The scribes obtained employing various laser conditions were characterized for electrical isolation and analyzed by optical microscopy followed by profilometry. High-quality scribing, with a scribe width of 53 μm over a length of 300 mm, was achieved on a bilayer Mo thin film sputtered on a Soda lime glass substrate.
Ämnesord och genrebeteckningar
Biuppslag (personer, institutioner, konferenser, titlar ...)
-
Joshi, Shrikant V.,1960-Högskolan Väst,Avdelningen för avverkande och additativa tillverkningsprocesser (AAT),PTW(Swepub:hv)shrjos
(författare)
-
Dhage, Sanjay R.Mechanical and Aerospace Engineering Department, University of California, Los Angeles, USA
(författare)
-
Centre for Solar Energy Materials, ARCI, Hyderabad, IndiaAvdelningen för avverkande och additativa tillverkningsprocesser (AAT)
(creator_code:org_t)
Sammanhörande titlar
-
Ingår i:Materials focusCalifornia, USA : American Scientific Publishers:4, s. 556-5622169-429X2169-4303
Internetlänk
Hitta via bibliotek
Till lärosätets databas