Sökning: L773:0165 4101 OR L773:1879 1980
> (2015-2019) >
In-process identifi...
In-process identification of modal parameters using dimensionless relationships in milling chatter
-
- Eynian, Mahdi, 1980- (författare)
- Högskolan Väst,Avdelningen för avverkande och additativa tillverkningsprocesser (AAT),PTW,University West, Department of Engineering Science, Trollhättan, Sweden
-
(creator_code:org_t)
- Elsevier BV, 2019
- 2019
- Engelska.
-
Ingår i: International journal of machine tools & manufacture. - : Elsevier BV. - 0890-6955 .- 1879-2170. ; 143, s. 49-62
- Relaterad länk:
-
https://hv.diva-port... (primary) (Raw object)
-
visa fler...
-
https://his.diva-por... (primary) (Raw object)
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
https://urn.kb.se/re...
-
visa färre...
Abstract
Ämnesord
Stäng
- Machining parameters needed for stable, high-performance high-speed machining could be found using mathematical models that need accurate measurements of modal parameters of the machining system. In-process modal parameters, however, can slightly differ from those measured offline and this can limit the applicability of simple measurement methods such as impact hammer tests. To study and extract the in-process modal parameters, mathematical models are used to define two key dimensionless parameters and establish their relationships with each other and the modal parameters. Based on these relationships, the modal parameters are extracted using two analytical methods, the two-point method (TPM), and the regression method (RM). As shown with experimental studies, the RM extracts the modal parameters successfully and while being much faster than the existing iteration-based methods, it provides stability lobe predictions that match well the experimental results. Furthermore, it is noted that the natural frequency parameter is estimated with much better relative precision compared to the damping ratio and the modal stiffness parameters. © 2019 Elsevier Ltd
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik -- Bearbetnings-, yt- och fogningsteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering -- Manufacturing, Surface and Joining Technology (hsv//eng)
Nyckelord
- Composite beams and girders
- Identification (control systems)
- Iterative methods
- Milling (machining)
- Modal analysis
- Regression analysis
- Accurate measurement
- Chatter
- Dimensionless parameters
- Frequency parameters
- High speed machining
- In-process
- Machining dynamics
- Stability lobe diagrams
- Parameter estimation
- Manufacturing and materials engineering
- Produktions- och materialteknik
- Production Technology
- Produktionsteknik
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas