An Elastic-Plastic Model for Single Shot-Peening Impacts

• A model was developed for impacts of elastic perfectly plastic spherical particles with impact velocities up to 250 m/s. The model is based on the two master curves, for normalized pressure and projected contact area c (2), which both are functions of the representative strain I > at maximum impact. The model and its parameters were fitted to finite element results for elastic perfectly plastic and strain rate-independent materials. It was applied to a wide range of materials with different ratio between yield stress and elastic properties, different ball sizes and impact velocities. The impact model predicted the results from finite element method for contact radius, maximum impact depth in both target and ball as well as remaining impact depth in target and ball. The remaining impact depth was determined from elastic spring back with Hertzian and quadratic pressure at maximum impact. The rebound velocity was also estimated by following the load-deformation path during spring back. If the strain rate-compensated yield stress was used for the master curve parameters, then the model predicted the impact results also for the investigated strain rate-dependent materials.

Subject headings

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Tribologi (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Tribology (hsv//eng)

Keyword

Shot peening

Contact mechanics

Impact

Elastic-plastic material

Strain rate hardening

Publication and Content Type

ref (subject category)

art (subject category)