SwePub
Sök i LIBRIS databas

  Utökad sökning

WFRF:(Wiesen S)
 

Sökning: WFRF:(Wiesen S) > (2008-2009) > Modelling of carbon...

Modelling of carbon migration during JET C-13 injection experiments

Strachan, J. D. (författare)
Likonen, J. (författare)
Coad, P. (författare)
visa fler...
Rubel, Marek J. (författare)
KTH,Fusionsplasmafysik
Widdowson, A. (författare)
Airila, M. (författare)
Andrew, P. (författare)
Brezinsek, S. (författare)
Corrigan, G. (författare)
Esser, H. G. (författare)
Jachmich, S. (författare)
Kallenbach, A. (författare)
Kirschner, A. (författare)
Kreter, A. (författare)
Matthews, G. F. (författare)
Philipps, V. (författare)
Pitts, R. A. (författare)
Spence, J. (författare)
Stamp, M. (författare)
Wiesen, S. (författare)
visa färre...
 (creator_code:org_t)
2008-08-28
2008
Engelska.
Ingår i: Nuclear Fusion. - : IOP Publishing. - 0029-5515 .- 1741-4326. ; 48:10
  • Tidskriftsartikel (refereegranskat)
Abstract Ämnesord
Stäng  
  • JET has performed two dedicated carbon migration experiments on the final run day of separate campaigns ( 2001 and 2004) using (CH4)-C-13 methane injected into repeated discharges. The EDGE2D/NIMBUS code modelled the carbon migration in both experiments. This paper describes this modelling and identifies a number of important migration pathways: ( 1) deposition and erosion near the injection location, ( 2) migration through the main chamber SOL, (3) migration through the private flux region (PFR) aided by E x B drifts and ( 4) neutral migration originating near the strike points. In H-Mode, type I ELMs are calculated to influence the migration by enhancing erosion during the ELM peak and increasing the long-range migration immediately following the ELM. The erosion/re-deposition cycle along the outer target leads to a multistep migration of C-13 towards the separatrix which is called 'walking'. This walking created carbon neutrals at the outer strike point and led to 13C deposition in the PFR. Although several migration pathways have been identified, quantitative analyses are hindered by experimental uncertainty in divertor leakage, and the lack of measurements at locations such as gaps and shadowed regions.

Nyckelord

scrape-off layer
diii-d
fusion devices
divertor plasmas
material
erosion
inner divertor
fuel inventory
target plates
asdex upgrade
deposition

Publikations- och innehållstyp

ref (ämneskategori)
art (ämneskategori)

Hitta via bibliotek

Till lärosätets databas

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy