An experimental and numerical study of the effect of some manufacturing defects

• During the manufacturing process of composite structural parts, layer of fabrics or unidirectional prepreg may have to be cut in order to fulfil production requirements. From a general mechanical point of view, cutting fibres in a composite part has a large negative impact on the mechanical properties. However, such interventions are necessary in particular cases, for example due to draping of complex geometries. A rather extensive test program was launched to investigate the effects of defects that typically could arise during manufacturing. The overall purpose of the test program was to determine knock-down factors on strength for typical manufacturing defects that occasionally arise and sometimes are hard to avoid in production: cuts/gaps and fibre angle deviations. Four types of specimens were tested, reference, intersection of cuts in adjacent layers combined with a bolt hole, cut in a zero degree ply combined with a bolt hole and specimens with misaligned fibres. The specimens with misaligned fibres were tested with three different fibre angles. In addition to the experimental procedure, FE-analyses utilising cohesive elements were conducted, and after mechanical tests, Non Destructive Investigation (NDI) and fractographic investigations were performed. An excellent correlation between analyses and experiments were obtained. 

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Materialteknik -- Kompositmaterial och -teknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Materials Engineering -- Composite Science and Engineering (hsv//eng)

Nyckelord

Experimental

Fractographic investigation

Manufacturing defect

Numerical analysis

SRA - Production

SRA - Produktion

Publikations- och innehållstyp

ref (ämneskategori)

kon (ämneskategori)