Sökning: hsv:(TEKNIK OCH TEKNOLOGIER) hsv:(Samhällsbyggnadsteknik) hsv:(Byggproduktion)
> (1990-1999) >
Behaviour of girder...
-
Granath, PerChalmers University of Technology
(författare)
Behaviour of girder webs subjected to patch loading
- Artikel/kapitelEngelska1999
Förlag, utgivningsår, omfång ...
Nummerbeteckningar
-
LIBRIS-ID:oai:DiVA.org:ltu-4796
-
https://urn.kb.se/resolve?urn=urn:nbn:se:ltu:diva-4796URI
-
https://doi.org/10.1016/S0143-974X(98)00240-5DOI
Kompletterande språkuppgifter
-
Språk:engelska
-
Sammanfattning på:engelska
Ingår i deldatabas
Klassifikation
-
Ämneskategori:ref swepub-contenttype
-
Ämneskategori:art swepub-publicationtype
Anmärkningar
-
Godkänd; 1999; 20080408 (ysko)
-
This paper concerns the behaviour of bridge girder webs subjected to concentrated forces that are introduced in the web during launching, a load case usually referred to as patch loading. So far, this type of loading has, in engineering practice, been dealt with using formulas originating from investigations concerning the ultimate load carrying capacity. Numerous bridge launchings have, however, led to unwanted damages of the girder web, i.e. plastic deformations of such magnitudes that the webs had to be repaired. To avoid these damages it is necessary to have a design method, for launching situations, which focuses more on avoiding some irreversible behaviour than on the ultimate load carrying capacity. Such a design method has to be based on a deeper understanding of the behaviour of the girder. In Ref. [1] the first author discusses the fact that yielding of the flange occurs only after the web plate has been severely damaged. This paper describes the deformation behaviour of the web plate due to patch loading. For small loads the deformations will be similar to the first linear buckling mode. As the load increases a smaller buckle, in the opposite direction, will start to develop in the web plate close to the load. This behaviour, which may be named post-critical buckling, occurs also for girders of a perfectly elastic material. The investigations are based on laboratory tests and non-linear finite element analyses of three typical girders representing different slenderness categories.
Ämnesord och genrebeteckningar
Biuppslag (personer, institutioner, konferenser, titlar ...)
-
Lagerqvist, OveLuleå tekniska universitet,Byggkonstruktion och -produktion(Swepub:ltu)ovelag
(författare)
-
Chalmers University of TechnologyByggkonstruktion och -produktion
(creator_code:org_t)
Sammanhörande titlar
-
Ingår i:Journal of constructional steel research50:1, s. 49-690143-974X1873-5983
Internetlänk
Hitta via bibliotek
Till lärosätets databas