Thin kerf cutting forces of frozen and non-frozen Norway spruce and Scots pine wood

• Reducing the kerf width in bandsawing has potential in reducing waste while optimising the yield. To be able to reduce the kerf width, understanding the cutting forces becomes critical. In this work, nine cutting teeth with varying band-body thicknesses and side clearances were tested by cutting both heartwood and sapwood of Norway spruce (Picea abies (L.) Karst.) and Scots pine (Pinus sylvestris L.) in frozen and non-frozen conditions. Single cutting teeth were moved into rotating wood samples in the 90–90° cutting direction, with chip thicknesses of 0.9 mm per cut. The main and normal cutting forces were measured. Scots pine had a higher density than Norway spruce and, therefore, a higher main cutting force. Non-frozen sapwood, non-frozen heartwood and frozen heartwood resulted in similar main cutting forces, but frozen sapwood resulted in significantly higher main cutting forces. Reducing the cutting width by about 45% resulted in an approximately 40% reduction in the main cutting force. The normal forces were not significantly affected by the species or cutting width. Frozen heartwood, non-frozen heartwood and non-frozen sapwood had similar normal cutting forces. Frozen sapwood had negative normal forces, and thus self-feeding was observed. 

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Annan maskinteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Other Mechanical Engineering (hsv//eng)

Nyckelord

Sawing

bandsawing

heartwood

sapwood

Träteknik

Wood Science and Engineering

Publikations- och innehållstyp

ref (ämneskategori)

art (ämneskategori)