Buoy Geometry, Size and Hydrodynamics for Power Take Off Device for Point Absorber Linear Wave Energy Converter

• Wave energy converters of point absorber type have been developed and constructed. Full scale experiments have been carried out at sea and electricity has been successfully delivered. Linear permanent magnet generators together with a subsea substation and buoys of various geometric shapes have been investigated theoretically and experimentally. The design has in large extent an electronic approach, keeping the mechanical part of it as simple as possible, due to the long life span and reliability of electric components.Because of the nature of a linear generator, the internal translator with permanent magnets has a limited stroke length which will be reached when the buoy is exposed to large wave heights. Internal springs at the top and bottom of the generator prevent the translator from hitting the generator hull. Inertial forces due to the mass and velocity of the translator and the buoy and its heave added mass compresses the spring. The added mass is a rather large part of the total moving mass. Simulations of a converter with a vertical cylindrical buoy and with a toroidal buoy were conducted, as well as real sea experiments with converters with cylindrical buoys of two different sizes and a toroidal buoy. The overloads are likely to affect the design and service life of the generator, the buoy and the wire which interconnects them.Buoy shapes with as much excitation force as possible and as little heave added mass as possible were sought. A toroidal buoy caused less overloads on the generator at sea states with short wave periods and relatively large wave height, but for sea states with very long wave periods or extremely high waves, the magnitude of the overloads was mainly determined by the maximum displacement of the buoy.Snap loads on the interconnecting wire, as the slack wire tensed up after a very deep wave trough, were found to be greater but of the same order of magnitude as forces during the rest of the wave cycle.During a 4 day period at various wave conditions, two converters with cylindrical buoys proved efficiency between 11.1 % and 24.4 %. The larger buoy had 78 % larger water plane area than the other buoy which resulted in 11 % more power production. Short wave period was beneficial for the power production.Infinite frequency heave added mass was measured for a cylindrical buoy at real sea and found to be greater than the linearly calculated theoretical added mass.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Energiteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Energy Engineering (hsv//eng)

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Strömningsmekanik och akustik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Fluid Mechanics and Acoustics (hsv//eng)

Nyckelord

point absorber

wave

energy

converter

ocean

wec

toroidal

buoy

torus

cylindrical

cylinder

experiment

full scale

trial

sea

energy

renewable

Engineering Science with specialization in Science of Electricity

Teknisk fysik med inriktning mot elektricitetslära

Publikations- och innehållstyp

vet (ämneskategori)

dok (ämneskategori)