SwePub
Sök i LIBRIS databas

  Extended search

WFRF:(Jansson Per O.)
 

Search: WFRF:(Jansson Per O.) > Synthesis and chara...

Synthesis and characterisation of Mo-B-C thin films deposited by non-reactive DC magnetron sputtering

Malinovskis, Paulius (author)
Uppsala universitet,Oorganisk kemi,Uppsala University, Sweden
Palisaitis, Justinas (author)
Linköpings universitet,Tunnfilmsfysik,Tekniska fakulteten
Persson, Per O A (author)
Linköpings universitet,Tunnfilmsfysik,Tekniska fakulteten
show more...
Jansson, Ulf (author)
Uppsala universitet,Oorganisk kemi,Uppsala University, Sweden
Lewin, Erik (author)
Uppsala universitet,Oorganisk kemi,Uppsala University, Sweden
show less...
 (creator_code:org_t)
ELSEVIER SCIENCE SA, 2017
2017
English.
In: Surface & Coatings Technology. - : ELSEVIER SCIENCE SA. - 0257-8972 .- 1879-3347. ; 309, s. 506-515
  • Journal article (peer-reviewed)
Abstract Subject headings
Close  
  • Thin films in the Mo-B-C system with varying carbon content (up to 37 at.%) were deposited using non-reactive DC magnetron sputtering. The phase composition and microstructure were determined and the potential use of the films in sliding electrical contact applications was evaluated. Films with lower than 23 at.% carbon content consisted of nanocrystalline MoB2 - x grains surrounded by an amorphous tissue phase (a-B for binary, and a-BCx for ternary films). With increasing carbon content grain sizes was found to decrease (from 16 to 5 nm), and above 23 at.% carbon the films deposited at room temperature were X-ray amorphous. Scanning transmission electron microscopy and energy dispersive X-ray spectroscopy reveal that these films contain Mo-rich and Mo-poor regions, and thus are two-phase amorphous nanocomposites. Low-carbon content samples exhibited a friction coefficient against the steel counter surface of 1.1; this was reduced to 0.8 for high carbon-content films. Analysis of the tribofilm revealed formation of molybdenum oxide and amorphous carbon, however without significant lubricating effect at room temperature. Hardness and elastic modulus decrease with carbon content from similar to 29 to similar to 22 GPa and similar to 526 to similar to 326 GPa. These values give an WE ratio of 0.06 to 0.07, indicating brittle material. Resistivity was found to increase with carbon content from similar to 175 mu Omega cm for binary Mo-B to similar to 395 mu Omega cm for Mo-B-C thin film with 37 at.% of C. Therefore all the above results suggest that the Mo-B-C films are not suitable for sliding electrical contacts.

Subject headings

NATURVETENSKAP  -- Kemi -- Materialkemi (hsv//swe)
NATURAL SCIENCES  -- Chemical Sciences -- Materials Chemistry (hsv//eng)
NATURVETENSKAP  -- Kemi -- Oorganisk kemi (hsv//swe)
NATURAL SCIENCES  -- Chemical Sciences -- Inorganic Chemistry (hsv//eng)

Keyword

Mo-B-C
Magnetron sputtering
Films
Hard coatings
Molybdenum diboride
Nanocomposite

Publication and Content Type

ref (subject category)
art (subject category)

Find in a library

To the university's database

Search outside SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Close

Copy and save the link in order to return to this view