Search: L773:0780309111
> (1993) >
Task planning for w...
Task planning for welding applications
-
Bolmsjö, Gunnar (author)
-
- Nikoleris, Giorgos (author)
- Lund University,Lunds universitet,Innovation,Institutionen för designvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,ID-A verkstaden,Department of Design Sciences,Departments at LTH,Faculty of Engineering, LTH,ID-A workshop,Faculty of Engineering, LTH
-
(creator_code:org_t)
- 1993
- 1993
- English 5 s.
-
In: Systems, Man and Cybernetics : Systems Engineering in the Service of Humans - Systems Engineering in the Service of Humans. - 0780309111 ; , s. 515-519
- Related links:
-
http://dx.doi.org/10...
-
show more...
-
https://lup.lub.lu.s...
-
https://doi.org/10.1...
-
show less...
Abstract
Subject headings
Close
- Welding robots that use sensors to compensate for variations in their environment pose new requirements for programming systems and for controller architectures. Tracking sensors must be programmed with the geometry of the welds and the motions of the robot. The process monitoring system must be programmed with the required process tolerances and the type of weld. Finally, the controller must be programmed with the motion parameters, velocity and end-pose. Task planning for welding applications is the specification of the geometrical and the technological parameters that are necessary to the above subsystems. The architecture of the controller also must be process-related to allow the flow of planning information to the different subsystems and the necessary feedback to the planning level. Data from the sensors must be used with path data, process information and the geometry of the welds to adjust the process in real time. This article describes the requirements of process-related programming and real-time control of industrial robots based on sensor data.
- Welding robots that use sensors to compensate for variations in their environment pose new requirements for programming systems and for controller architectures. Tracking sensors must be programmed with the geometry of the welds and the motions of the robot. The process monitoring system must be programmed with the required process tolerances and the type of weld. Finally, the controller must be programmed with the motion parameters, velocity and end-pose. Task planning for welding applications is the specification of the geometrical and the technological parameters that are necessary to the above subsystems. The architecture of the controller also must be process-related to allow the flow of planning information to the different subsystems and the necessary feedback to the planning level. Data from the sensors must be used with path data, process information and the geometry of the welds to adjust the process in real time. This article describes the requirements of process-related programming and real-time control of industrial robots based on sensor data.
Subject headings
- TEKNIK OCH TEKNOLOGIER -- Elektroteknik och elektronik -- Robotteknik och automation (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Electrical Engineering, Electronic Engineering, Information Engineering -- Robotics (hsv//eng)
Publication and Content Type
- kon (subject category)
- ref (subject category)
Find in a library
To the university's database