Sökning: WFRF:(Bastiaans R. J. M.)
> (2009) >
Visualization of Bi...
-
Prins, A. J.
(författare)
Visualization of Biomass Pyrolysis and Temperature Imaging in a Heated-Grid Reactor
- Artikel/kapitelEngelska2009
Förlag, utgivningsår, omfång ...
-
2009-02-02
-
American Chemical Society (ACS),2009
Nummerbeteckningar
-
LIBRIS-ID:oai:lup.lub.lu.se:acf6c680-f699-4380-aa8e-b28c8db9e164
-
https://lup.lub.lu.se/record/1371919URI
-
https://doi.org/10.1021/ef800419wDOI
Kompletterande språkuppgifter
-
Språk:engelska
-
Sammanfattning på:engelska
Ingår i deldatabas
Klassifikation
-
Ämneskategori:art swepub-publicationtype
-
Ämneskategori:ref swepub-contenttype
Anmärkningar
-
The main advantage of a heated-grid reactor for studying pyrolysis kinetics of solid fuel samples is that high heating rates of up to 1000 K/s can be obtained. However, one of the concerns is whether the temperature distribution over the grid material is uniform and whether the presence of a thermocouple welded to the grid causes any measurement errors. Biomass samples were placed on the heated-grid reactor, and the volatiles, emitted in the biomass pyrolysis process as hot gas plumes, were imaged with an infrared camera with a high framing speed. The temporal resolved infrared images indicate that the pyrolysis process does not take place at the same rate everywhere on the grid. Two-dimensional temperature images of a heated grid made of stainless steel were recorded using the method of laser-induced thermometry with thermographic phosphors. As expected from a heat-transfer model, measured temperatures were found to be significantly higher than temperatures indicated by a thermocouple welded to the bottom of the grid. It was also observed that there is a large temperature gradient between the two electrodes on which the grid is connected. It is shown that replacing a wire mesh by a foil as a grid material may lead to more homogeneous temperature distribution. The paper recommends additional research to demonstrate the suitability of the heated-grid reactor for carrying out accurate measurements.
Ämnesord och genrebeteckningar
Biuppslag (personer, institutioner, konferenser, titlar ...)
-
Lindén, JohannesLund University,Lunds universitet,Förbränningsfysik,Fysiska institutionen,Institutioner vid LTH,Lunds Tekniska Högskola,Combustion Physics,Department of Physics,Departments at LTH,Faculty of Engineering, LTH(Swepub:lu)forb-jal
(författare)
-
Li, ZhongshanLund University,Lunds universitet,Förbränningsfysik,Fysiska institutionen,Institutioner vid LTH,Lunds Tekniska Högskola,Combustion Physics,Department of Physics,Departments at LTH,Faculty of Engineering, LTH(Swepub:lu)forb-zli
(författare)
-
Bastiaans, R. J. M.
(författare)
-
van Oijen, J. A.
(författare)
-
Aldén, MarcusLund University,Lunds universitet,Förbränningsfysik,Fysiska institutionen,Institutioner vid LTH,Lunds Tekniska Högskola,Combustion Physics,Department of Physics,Departments at LTH,Faculty of Engineering, LTH(Swepub:lu)forb-mal
(författare)
-
de Goey, L. P. H.
(författare)
-
FörbränningsfysikFysiska institutionen
(creator_code:org_t)
Sammanhörande titlar
-
Ingår i:Energy & Fuels: American Chemical Society (ACS)23:1, s. 993-10060887-06241520-5029
Internetlänk
Hitta via bibliotek
Till lärosätets databas