Sökning: WFRF:(Andersson Karin 1952)
> (2020-2022) >
On the effects of i...
On the effects of increased coolant temperatures of light duty engines on waste heat recovery
-
- Singh, Vikram (författare)
- Lund University,Lunds universitet,Förbränningsmotorer,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Combustion Engines,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Rijpkema, Jelmer Johannes, 1982 (författare)
- Chalmers University of Technology
-
- Munch, Karin, 1954 (författare)
- Chalmers University of Technology
-
visa fler...
-
- Andersson, Sven B, 1952 (författare)
- Chalmers University of Technology
-
- Verhelst, Sebastian (författare)
- Lund University,Lunds universitet,Förbränningsmotorer,Institutionen för energivetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Combustion Engines,Department of Energy Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- Elsevier BV, 2020
- 2020
- Engelska.
-
Ingår i: Applied Thermal Engineering. - : Elsevier BV. - 1359-4311. ; 172
- Relaterad länk:
-
http://dx.doi.org/10...
-
visa fler...
-
https://research.cha...
-
https://doi.org/10.1...
-
https://lup.lub.lu.s...
-
visa färre...
Abstract
Ämnesord
Stäng
- In this paper, an investigation is done into the potential of increasing the coolant temperature of an engine to maximize the powertrain efficiency. The study takes a holistic approach by trying to optimise the combined engine and waste heat recovery system. The work was done experimentally on a Volvo 4-cylinder light duty diesel engine in combination with Rankine cycle simulations. For the study, the coolant temperature was swept from 80 °C to 160 °C at different operating points. It was seen that with increased coolant temperatures, the brake efficiency of the engine increased by up to 1 percentage point due to reduced heat losses. An optimum coolant temperature was observed, dependent on the operating point, for maximizing coolant recoverable power. An expansive study was done simulating 48 working fluids for a dual loop waste heat recovery system. From the working fluids simulated, cyclopentane was seen as the best for coolant waste heat recovery, whereas methanol and acetone were better for the exhaust gases. The gain in efficiency seen, was up to 5.2 percentage points, with up to 1.7 percentage points as the effect due to recovered power from the coolant.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Annan maskinteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Other Mechanical Engineering (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Energiteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Energy Engineering (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Naturresursteknik -- Marin teknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Environmental Engineering -- Marine Engineering (hsv//eng)
Nyckelord
- Elevated coolant temperatures
- Recoverable power
- Reduced heat losses
- Low temperature waste heat recovery
- Rankine cycle
- Light duty engine
- Elevated coolant temperatures
- Light duty engine
- Low temperature waste heat recovery
- Rankine cycle
- Recoverable power
- Reduced heat losses
Publikations- och innehållstyp
- art (ämneskategori)
- ref (ämneskategori)
Hitta via bibliotek
Till lärosätets databas