Sökning: WFRF:(Varga Imre) >
Buildup of polyelec...
Buildup of polyelectrolyte multilayers of polyethyleneimine and microfibrillated cellulose studied by in situ dual-polarization interferometry and quartz crystal microbalance with dissipation
-
- Aulin, Christian, 1980- (författare)
- KTH,Yt- och korrosionsvetenskap,Fiberteknologi
-
- Varga, Imre, 1966- (författare)
- KTH,Yt- och korrosionsvetenskap
-
- Claesson, Per, 1957- (författare)
- RISE,KTH,Yt- och korrosionsvetenskap,YKI – Ytkemiska institutet
-
visa fler...
-
- Wågberg, Lars, 1956- (författare)
- KTH,Fiberteknologi
-
- Lindström, Tom (författare)
- RISE,STFI-Packforsk,STFI-Packforsk AB
-
visa färre...
-
(creator_code:org_t)
- 2008-02-16
- 2008
- Engelska.
-
Ingår i: Langmuir. - : American Chemical Society (ACS). - 0743-7463 .- 1520-5827. ; 24:6, s. 2509-2518
- Relaterad länk:
-
http://pubs.acs.org/...
-
visa fler...
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
https://urn.kb.se/re...
-
https://urn.kb.se/re...
-
visa färre...
Abstract
Ämnesord
Stäng
- Polyethyleneimine (PEI) and Microfibrillated cellulose (MFC) have been used to buildup polyelectrolyte multilayers (PEM) on silicone oxide and silicone oxynitride surfaces at different pH values and with different electrolyte and polyelectrolyte/colloid concentrations of the components. Consecutive adsorption on these surfaces was studied by in situ dual-polarization interferometry (DPI) and quartz crystal microbalance measurements. The adsorption data obtained from both the techniques showed a steady buildup of multilayers. High pH and electrolyte concentration of the PEI solution was found to be beneficial for achieving a high adsorbed amount of PEI, and hence of MFC, during the buildup of the multilayer. On the other hand, an increase in the electrolyte concentration of the MFC dispersion was found to inhibit the adsorption of MFC onto PEL The adsorbed amount of MFC was independent of the bulk MFC concentration in the investigated concentration range (15-250 mg/L). Atomic force microscopy measurements were used to image a MFC-treated silicone oxynitride chip from DPI measurements. The surface was found to be almost fully covered by randomly oriented microfibrils after the adsorption of only one bilayer of PEI/MFC. The surface roughness expressed as the rms-roughness over 1 ÎŒm2 was calculated to be 4.6 nm (1 bilayer). The adsorbed amount of PEI and MFC and the amount of water entrapped by the individual layers in the multilayer structures were estimated by combining results from the two analytical techniques using the de Feijter formula. These results indicate a total water content of ca. 41% in the PEM.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Materialteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Materials Engineering (hsv//eng)
- TEKNIK OCH TEKNOLOGIER -- Nanoteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Nano-technology (hsv//eng)
- NATURVETENSKAP -- Kemi -- Polymerkemi (hsv//swe)
- NATURAL SCIENCES -- Chemical Sciences -- Polymer Chemistry (hsv//eng)
Nyckelord
- PAPER STRENGTH PROPERTIES; ADSORPTION PROPERTIES; SILICA SURFACES; WOOD FIBERS; THIN-FILMS; PROTEIN; ELLIPSOMETRY; KINETICS; GROWTH
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
-
Langmuir
(Sök värdpublikationen i LIBRIS)
Till lärosätets databas