Sökning: WFRF:(Zhou Jinming) >
Modelling Subsurfac...
Modelling Subsurface Deformation in High Speed Machining of Inconel 718
-
- Agmell, Mathias (författare)
- Lund University,Lunds universitet,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Zhou, Jinming (författare)
- Lund University,Lunds universitet,Industriell Produktion,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Production and Materials Engineering,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
- Ahadi, Aylin (författare)
- Lund University,Lunds universitet,Mekanik,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Mechanics,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa fler...
-
- Bushlya, Volodymyr (författare)
- Lund University,Lunds universitet,Industriell Produktion,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Production and Materials Engineering,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
Peng, R.L. (författare)
-
- Ståhl, Jan-Eric (författare)
- Lund University,Lunds universitet,Industriell Produktion,Institutionen för maskinvetenskaper,Institutioner vid LTH,Lunds Tekniska Högskola,Production and Materials Engineering,Department of Mechanical Engineering Sciences,Departments at LTH,Faculty of Engineering, LTH
-
visa färre...
-
(creator_code:org_t)
- 2012
- 2012
- Engelska 9 s.
- Relaterad länk:
-
https://lup.lub.lu.s...
Abstract
Ämnesord
Stäng
- Abstract in UndeterminedTraditionally, the development and optimization of the machining process with regards to the sub-surface deformation is done through experimental method which is often expensive and time consume. This paper presents the development of a FE-simulation model to predict the depth of sub-surface deformation induced in the high speed machining of Inconel 718 by use of whisker-reinforced ceramic tool. The effects of cutting parameters and geometry on sub-surface deformation will be simulated by developed FE model. In addition to FE model, the experimental study was made to validate the results of FE model. Characterization of sub-surface deformation produced under different machining parameters and tool conditions was made by EBSD and in the cutting and feed directions.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering (hsv//eng)
Publikations- och innehållstyp
- kon (ämneskategori)
- ref (ämneskategori)