SwePub
Sök i LIBRIS databas

  Utökad sökning

WFRF:(Lekholm Ville)
 

Sökning: WFRF:(Lekholm Ville) > Investigation of a ...

LIBRIS Formathandbok  (Information om MARC21)
FältnamnIndikatorerMetadata
00003771naa a2200349 4500
001oai:DiVA.org:uu-246059
003SwePub
008150302s2015 | |||||||||||000 ||eng|
024a https://urn.kb.se/resolve?urn=urn:nbn:se:uu:diva-2460592 URI
024a https://doi.org/10.1088/0960-1317/25/6/0650142 DOI
040 a (SwePub)uu
041 a engb eng
042 9 SwePub
072 7a ref2 swepub-contenttype
072 7a art2 swepub-publicationtype
100a Lekholm, Ville,d 1976-u Uppsala universitet,Mikrosystemteknik,ÅSTC4 aut0 (Swepub:uu)ville816
2451 0a Investigation of a zirconia co-fired ceramic calorimetric microsensor for high-temperature flow measurements
264 c 2015-05-19
264 1b IOP Publishing,c 2015
338 a print2 rdacarrier
520 a This paper describes the design, fabrication and characterization of a flow sensor for high-temperature, or otherwise aggressive, environments, like, e.g. the propulsion system of a small spacecraft. The sensor was fabricated using 8 mol% yttria stabilized zirconia (YSZ8) high-temperature co-fired ceramic (HTCC) tape and screen printed platinum paste. A calorimetric flow sensor design was used, with five 80 mu m wide conductors, separated by 160 mu m, in a 0.4 mm wide, 0.1 mm deep and 12.5 mm long flow channel. The central conductor was used as a heater for the sensor, and the two adjacent conductors were used to resistively measure the heat transferred from the heater by forced convection. The two outermost conductors were used to study the influence of an auxiliary heat source on the sensor. The resistances of the sensor conductors were measured using four-point connections, as the gas flow rate was slowly increased from 0 to 40 sccm, with different power supplied through the central heater, as well as with an upstream or downstream heater powered. In this study, the thermal and electrical integrability of microcomponents on the YSZ8 substrate was of particular interest and, hence, the influence of thermal and ionic conduction in the substrate was studied in detail. The effect of the ion conductivity of YSZ8 was studied by measuring the resistance of a platinum conductor and the resistance between two adjacent conductors on YSZ8, in a furnace at temperatures from 20 to 930 degrees C and by measuring the resistance with increasing current through a conductor. With this design, the influence of ion conductivity through the substrate became apparent above 700 degrees C. The sensitivity of the sensor was up to 1 m Omega sccm(-1) in a range of 0-10 sccm. The results show that the signal from the sensor is influenced by the integrated auxiliary heating conductors and that these auxiliary heaters provide a way to balance disturbing heat sources, e.g. thrusters or other electronics, in conjunction with the flow sensor.
650 7a TEKNIK OCH TEKNOLOGIERx Annan teknik0 (SwePub)2112 hsv//swe
650 7a ENGINEERING AND TECHNOLOGYx Other Engineering and Technologies0 (SwePub)2112 hsv//eng
653 a Teknisk fysik med inriktning mot mikrosystemteknik
653 a Engineering Science with specialization in Microsystems Technology
700a Persson, Andersu Uppsala universitet,Mikrosystemteknik4 aut0 (Swepub:uu)andpe782
700a Klintberg, Lenau Uppsala universitet,Mikrosystemteknik4 aut0 (Swepub:uu)lkl28025
700a Thornell, Gregeru Uppsala universitet,Mikrosystemteknik,ÅSTC4 aut0 (Swepub:uu)gth12095
710a Uppsala universitetb Mikrosystemteknik4 org
773t Journal of Micromechanics and Microengineeringd : IOP Publishingg 25:6q 25:6x 0960-1317x 1361-6439
8564 8u https://urn.kb.se/resolve?urn=urn:nbn:se:uu:diva-246059
8564 8u https://doi.org/10.1088/0960-1317/25/6/065014

Hitta via bibliotek

Till lärosätets databas

Hitta mer i SwePub

Av författaren/redakt...
Lekholm, Ville, ...
Persson, Anders
Klintberg, Lena
Thornell, Greger
Om ämnet
TEKNIK OCH TEKNOLOGIER
TEKNIK OCH TEKNO ...
och Annan teknik
Artiklar i publikationen
Journal of Micro ...
Av lärosätet
Uppsala universitet

Sök utanför SwePub

Kungliga biblioteket hanterar dina personuppgifter i enlighet med EU:s dataskyddsförordning (2018), GDPR. Läs mer om hur det funkar här.
Så här hanterar KB dina uppgifter vid användning av denna tjänst.

 
pil uppåt Stäng

Kopiera och spara länken för att återkomma till aktuell vy