Experimental Investigation of the Influence of Flow Obstacles on Post-Dryout Heat Transfer in an Annulus

• This paper describes the experimental setup, instrumentation and procedures which have been developed in the thermal-hydraulic laboratory at the Royal Institute of Technology (KTH), Stockholm, Sweden, to perform new post-dryout heat transfer investigations in an annulus with flow obstacles. Previous investigations performed in the same laboratory indicated that flow obstacles had a considerable influence on the post-CHF heat transfer. The measured heat transfer enhancement was significantly under-predicted by existing models. However, the net effect of obstacles could not be deduced from the measurements, since reference - obstacle-free measurements- had not been performed. In addition, the number of thermocouples that could be installed inside the heated rod was limited to 8. These deficiencies have been removed in the current approach. Firstly, the present design of the test section allows for measurements both with and without flow obstacles. In this way the net effect of the obstacles will be captured. Secondly, a newly developed technique allowed the installation of 40 thermocouples inside of the heated rod. An additional 40 thermocouples have been installed on the external wall of the heated tube. Therefore, a significant improvement of the accuracy of measurements can be expected. The present arrangement of instrumentation is suitable to perform measurements of heat transfer under both steady-state and transient conditions.

Ämnesord

TEKNIK OCH TEKNOLOGIER  -- Maskinteknik -- Energiteknik (hsv//swe)

ENGINEERING AND TECHNOLOGY  -- Mechanical Engineering -- Energy Engineering (hsv//eng)

Nyckelord

Experimental investigations

Experimental setup

External walls

Heat Transfer enhancement

Heated tubes

Net effect

Post-dryout

Royal Institute of Technology

Stockholm

Sweden

Test sections

Thermal hydraulics

Transient conditions

Computer crime

Heat exchangers

Heat transfer

Instruments

Nuclear engineering

Nuclear industry

Thermocouples

Thermometers

Mechanical and thermal engineering

Mekanisk och termisk energiteknik

Publikations- och innehållstyp

ref (ämneskategori)

kon (ämneskategori)