Sökning: L773:2238 7854 OR L773:2214 0697
> (2019) >
Characterization of...
Characterization of DLC coatings over nitrided stainless steel with and without nitriding pre-treatment using annealing cycles
-
- Dalibon, Eugenia. L. (författare)
- UTN, Argentina
-
- Czerwiec, Thierry (författare)
- Univ Lorraine, France
-
- Trava-Airoldi, Vladimir J. (författare)
- INPE, Brazil
-
visa fler...
-
- Ghafoor, Naureen (författare)
- Linköpings universitet,Tunnfilmsfysik,Tekniska fakulteten
-
- Rogström, Lina (författare)
- Linköpings universitet,Nanostrukturerade material,Tekniska fakulteten
-
- Odén, Magnus (författare)
- Linköpings universitet,Nanostrukturerade material,Tekniska fakulteten
-
- Bruhl, Sonia P. (författare)
- UTN, Argentina
-
visa färre...
-
(creator_code:org_t)
- ELSEVIER SCIENCE BV, 2019
- 2019
- Engelska.
-
Ingår i: Journal of Materials Research and Technology. - : ELSEVIER SCIENCE BV. - 2238-7854 .- 2214-0697. ; 8:2, s. 1653-1662
- Relaterad länk:
-
https://liu.diva-por... (primary) (Raw object)
-
visa fler...
-
https://doi.org/10.1...
-
https://urn.kb.se/re...
-
https://doi.org/10.1...
-
visa färre...
Abstract
Ämnesord
Stäng
- Amorphous hydrogenated diamond-like carbon (DLC) coatings were deposited using plasma assisted chemical vapour deposition (PACVD) on precipitation hardening (PH) stainless steel.Plasma nitriding has been used as pre-treatment to enhance adhesion and mechanical properties. Chemical and mechanical properties of DLC coatings are dependent on the hydrogen content and so on the relation between sp(3)/sp(2) bondings. The bondings and the structure of the DLC film change with temperature. In this work, a study of the thermal degradation and the evolution of the mechanical properties of DLC coatings over PH stainless steel have been carried out, including the effect of an additional nitrided layer. Nitrided and non-nitrided steel samples were subjected to the same coated in the same conditions, and they were submitted to the same thermal cycles, heating from room temperature to 600 degrees C in several steps. After each cycle, Raman spectra and surface topography measurements were performed and analyzed. Nanohardness measurements and tribological tests, using a pin-on-disc machine, were carried out to analyze variations in the friction coefficient and the wear resistance. The duplex sample, with nitriding as pre-treatment showed a better thermal stability. For duplex sample, the coating properties, such as adhesion, and friction coefficient were sustained after annealing at higher temperatures; whereas it was not the case for only coated sample. (C) 2018 Brazilian Metallurgical, Materials and Mining Association. Published by Elsevier Editora Ltda.
Ämnesord
- TEKNIK OCH TEKNOLOGIER -- Maskinteknik -- Tribologi (hsv//swe)
- ENGINEERING AND TECHNOLOGY -- Mechanical Engineering -- Tribology (hsv//eng)
Nyckelord
- DLC coatings; Thermal stability; Duplex treatment; Nitriding
Publikations- och innehållstyp
- ref (ämneskategori)
- art (ämneskategori)
Hitta via bibliotek
Till lärosätets databas